Fig. 222 A: removing the trim B: detaching the connector and removing the bulb holderFirst read and observe the introductory information and safety warningsвЂ‰
The actions should be carried out in the given order only.
Removing the tail light cluster
|The jobs should be carried out in the given order only:|
|1.||Observe and follow the instructions on the checklist вЂ‰ .|
|2.||Take the wire hook from the vehicle tools (вЂ‰ ) and insert it into the small aperture in the tail light cluster cover вЂ‰ A. Turn the hook towards the centre of the vehicle and pull the cover out by approximately 1 cm in the direction of the arrow.|
|3.||Pull the cover down first and then up and towards you. You can now see a screw behind the cover.|
|4.||Use the flat blade of the screwdriver from the vehicle tool kit to remove the screw.|
|5.||Push rear light cluster carefully towards the outside of the vehicle until it audibly disengages at the two latching points (ball heads).|
|6.||Press the catch of the connector in the direction of the arrow.|
|7.||Remove the connector вЂ‰ B.|
|8.||Carefully pull the tail light cluster to the rear to remove it from the body. Place it on a clean, smooth surface.|
Changing the bulb
|9.||Use the screwdriver from the tool kit to unscrew the four securing bolts вЂ‰ (arrows) вЂ‰ .|
|10.||Remove the bulb holder from the tail light cluster.|
|11.||Replace the defective bulb with a new bulb of the same type.|
|12.||Insert the bulb holder into the tail light cluster.|
|13.||Use the screwdriver to screw in the four securing bolts.|
|14.||Connect the connector вЂ‰ to the bulb holder. The connector should audibly click into place.|
Fitting the tail light cluster
|15.||Place rear light cluster in position against the car body and press it towards the middle of the vehicle until it audibly engages at the two latching points (ball heads).|
|16.||Use one hand to hold the tail light cluster in the fitting position while using the other hand to screw the securing bolt firmly back in with the flat blade of the screwdriver from the tool kit вЂ‰ .|
|17.||First fit the tail cluster trim at the bottom and then fit it at the top in the original position.|
|18.||Check that the tail light cluster is positioned correctly and securely.|
|19.||Close the tailgate вЂ‰ .|
Due to different versions of the tail light cluster, the location of the bulbs may differ slightly to that shown in the illustrations.
Volkswagen Touran Owners Manual. Introduction
This chapter contains information on the following subjects: → Folding backrests in the second row of seats forwards and backwards → Folding the seats on the second row of seats forwards and backwards → Removing the seats in the second row of ...
Volkswagen Touran Service Manual. Pressure Relief Valve
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...