Volkswagen Touran Service Manual: Corrosion Protection for Body, Attached and Welded Parts
|Coat the insides of the fenders, doors, covers and lids
completely. A spray application wet in wet procedure is
|Before assembly, the seal the inside of the attachments with
cavity sealant (refer to
→ Chapter "Preservation") so as to recreate the
original state. Refer to "Vehicle-Specific
|Vehicles with wheel housing liners must have an additional
chafe protection on the wheel housing. Refer to
→ Chapter "Fender Corrosion Repair Measures, in Wheel Housing
Liner Contact Area".
|All welded parts except the roof are to be completely primed
and filled on the inside. The visible inner surfaces must be
coated with a spray application of base pant and clear coat. If
necessary perform this before welding. In case of doubt, the
production status applies.
|If sealing is required this is to take place after the
specified paint structure.
|Coat all parts that form cavities, such as pillars, braces,
side panels, etc., with cavity sealant. Refer to
→ Chapter "Preservation".
|All parts in the series production that are coated with
noise-damping or stone chip protection material (for example
wheel housing, floor panel, front/rear cross panels or outer
side sill) need to be coated as follows:
|Wheel housings and underbody with sprayable weld sealant.
→ Chapter "Sealing Materials".
|Even out large creases or thick layers with base material
Adhesive Sealant -D 511 500 A2-.
|Sill panel region, lower side panel, rear cross panel
corners with stone chip protection. Refer to
→ Chapter "Stone Chip Protection".
Corrosion on the Fold Edges, for Instance on the Hood, Door
or also the Rear Lid
Remove the corroded areas with
→ Chapt ...
The following parameters must be met when painting to avoid
malfunctions in the parking aid sensor (parking aid system):
New Part, Painting
Volkswagen Touran Owners Manual. Lower section of the centre console
Fig. 8 Overview of the lower section of
the centre console (left-hand drive vehicles)
Fig. 9 Overview of the lower section of
the centre console (right-hand drive vehicles)
Key for вЂ‰ and вЂ‰:
Cigarette lighter вЂ‰ or 12-volt socket вЂ‰
Lever for: ...
Volkswagen Touran Service Manual. Heel and Toe Wear
Heel-and-toe wear is step-like wear of individual tread
blocks, due to which an increased rolling noise can develop. The
heel-and-toe wear is caused by the uneven distortion of the
tread blocks in the contact patch. Heel-and-toe wear appears in
more extr ...
2017-2021 © Copyright www.oticasveja.site