Volkswagen Touran Service Manual: Fender Corrosion Repair Measures, in Wheel Housing Liner Contact Area
|The corrosion protection in the fender seam must be applied on all
replacement parts, on which the attached seal is not already present.
|The additional corrosion protection seal will prevent "chafe marks"
in the fender wheel housing liner.
||Apply filler to the interior and exterior areas of the fender.
||Once the filler has dried, apply and spread the Sealing Material -D
511 500 A2- in the wheel housing liner contact area (fender seam).
|The dimension -b- can vary, because the
fender has different folded edge widths. Note that the entire folded
edge is always sealed.
|Before installing, the inner sides of the wheel housing and
the fillet plate are to be sealed with cavity sealant.
→ Chapter "Preservation".
Dry sand the cataphoretic primer on the roof adhesive
surface -item 6-
→ Item down to the bare metal using P180 sandpaper.
Corrosion on the Fold Edges, for Instance on the Hood, Door
or also the Rear Lid
Remove the corroded areas with
→ Chapt ...
2017-2021 © Copyright www.oticasveja.site