VW Touran manuals

Volkswagen Touran Service Manual: Flat Connector Systems

  Note
If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter "Secondary Lock".
   
Flat Connector System with One Retaining Tab
  Guide the release tool which fits the contact housing into release channel on contact housing.
  Grasp contact at wire and push it gently into contact housing -arrow-.
  Note
By pushing the contact in the direction of the contact housing, the contact retaining tab is lifted off the housing shoulder and can be released using the release tool.
  Flat Connector Systems
  At the same time, push release tool in direction of contact housing and pull the released contact out of contact housing -arrow-.
  After removing the contact, release tool can be pulled out of the contact housing again.
  Flat Connector Systems
Flat Connector System with Two Retaining Tabs
  Guide the release tool which fits the contact housing into release channel on contact housing.
  Grasp contact at wire and push it gently into contact housing until it stops in direction of -arrow-.
  Note
By pushing the contact in the direction of the contact housing, the contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.
  Flat Connector Systems
  At the same time, push release tool in direction of contact housing and pull the released contact out of contact housing in direction of -arrow-.
  After removing the contact, release tool can be pulled out of the contact housing again.
  Flat Connector Systems
Asymmetrical
  Guide the release tool which fits the contact housing into release channel on contact housing.
  Grasp contact at wire and push it gently into contact housing -arrow-.
  Note
By pushing the contact in the direction of the contact housing, the contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.
  Flat Connector Systems
  At the same time, push release tool in direction of contact housing and pull the released contact out of contact housing -arrow-.
  After removing the contact, release tool can be pulled out of the contact housing again.
  Flat Connector Systems
    Round Connector Systems
      Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer ...

    Special Connector Systems
      Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer ...

    Other materials:

    Volkswagen Touran Owners Manual. Checking the electrolyte level of the vehicle battery
    Fig. 179 In the engine compartment: removing the battery cover Fig. 180 Engine compartment: pushing up the vehicle battery sleeve First read and observe the introductory information and safety warnings The electrolyte level of the vehicle battery should be checked regularly in high-mil ...

    Volkswagen Touran Owners Manual. Wheel bolt caps
    Fig. 205 Removing the wheel bolt caps First read and observe the introductory information and safety warnings  Take the wire hook from the tool kit   . Insert the hook through the opening in the cap   and pull off in the direction of the arrow. The caps protect the wheel b ...

    2017-2021 © Copyright www.oticasveja.site