Volkswagen Touran Service Manual: Releasing and Disassembly Contact Housings, General Information
|Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter "Vehicle Electrical System, General Repair
|Always use the release tools intended for the releasing
process. Under no circumstances may terminals be pulled
forcefully out of terminal housings.
|Damaged contact housings must always be replaced. New
contact housings may be ordered via OTC Kassel.
|Small screwdrivers may be used as an aid to release the
|Chamber/pin assignment is located partially stamped in on
secondary lock or rear side of terminal housing.
|Detailed information on component locations of harness
connectors. Refer to
→ Wiring diagrams, Troubleshooting & Component locations.
|The allocation of the correct release tools to the
respective locking mechanisms can be found in the table in the
Release Tool Set -VAS1978/35- Operating Instructions.
For technical reasons, the contact housing for the wire
terminals can be supplied only with the contacts p ...
The secondary lock is a housing securing mechanism (second
locking mechanism) that secures all wires in one contact
housing. If a secondary lock is installed at a con ...
2017-2021 © Copyright www.oticasveja.site