VW Touran manuals

Volkswagen Touran Service Manual: Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing

Volkswagen Touran Service Manual / Wheel  and Tire Guide Information / Tire Pressure Sensor / Tire Pressure Monitoring Sensor, Removing and Installing / Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing

  WARNING
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
The Siemens wheel electronics does not have a microencapsulated screw.
A union nut holds the wheel electronics in place inside the rim -item 2- → Item.
The metal valve body serves as an antenna.
The connection between the metal valve body to the wheel electronics must not get damaged.
  WARNING
Counterhold the metal valve from the back by hand when pressing the wheel electronics into the bed on the rim. The connection between the metal valve to the wheel electronics must not get interrupted or damaged. Damaged wheel electronics must be replaced.
  Press the wheel electronics into the bed.
  Tighten the wheel electronics to the metal valve with the union nut. Refer to → Chapter "Tire Pressure Sensor and Metal Valve, Removing and Installing"
Tightening Specifications. Refer to → Anchor.
   
    Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing
    Overview, Beru System   WARNING If tire sealant was used, then the wheel electronics on that particul ...

    Tire Sealant
    Tire Sealant, Expiration Date Tire sealant in the bottle has a limited storage life.     Therefore, the expiration dat ...

    Other materials:

    Volkswagen Touran Owners Manual. Retrofitting a towing bracket
    Fig. 108 Dimensions and attachment points for retrofitting a towing bracket First read and observe the introductory information and safety warnings Volkswagen recommends having the towing bracket retrofitted by a qualified workshop. The cooling system may need to be modified or heat ...

    Volkswagen Touran Service Manual. Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
    Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

    2017-2021 © Copyright www.oticasveja.site